Lamda Tester and Simulator
Model :
ADT-00072
ADT-00072
Lamda Tester and Simulator
This device is designed to test and
to simulate 1V Zirconia and 1V/5V
Titania type oxygen sensors.
The simulation can help user to
exam the function of the ECU.
Moreover, it can analyze the type of
connection wire.
●Testing 1 ~ 4 wires
(with/without heater) oxygen sensor
(1V Zirconia, 1V/5V Titania).
●Connection wires analysis (ground, open, heater, ECU power).
●Check the ECU response to the sensor by simulating rich/lean signals.
●LED indication of oxygen sensor signal switching and low power indication.
●With wire piercing clip (easy for connection), 5 minutes auto power off,
proper sealed control panel, high strength housing.
Lamda Tester and Simulator
This device is designed to test and
to simulate 1V Zirconia and 1V/5V
Titania type oxygen sensors.
The simulation can help user to
exam the function of the ECU.
Moreover, it can analyze the type of
connection wire.
●Testing 1 ~ 4 wires
(with/without heater) oxygen sensor
(1V Zirconia, 1V/5V Titania).
●Connection wires analysis (ground, open, heater, ECU power).
●Check the ECU response to the sensor by simulating rich/lean signals.
●LED indication of oxygen sensor signal switching and low power indication.
●With wire piercing clip (easy for connection), 5 minutes auto power off,
proper sealed control panel, high strength housing.
